Capsule Machine Size 1

Details:

Material: Plastic

General information about the Capsule Machine:

The Capsule Machine is a device that allows you to quickly and easily fill your own capsules.

- Automatic closing and ejection of filled capsules
- Faster and easier to use than other products
- Fills 24 capsules in just a few minutes!

- Available in three sizes: #00, #0, and #1 - each size only works with capsules of the same size

Fill your own capsules:

- Create your own mixes with your favorite ingredients
- Use high-quality and fresh ingredients
- Save up to 75%
- Avoid binders or excipients

How to use:

1. Read the green instruction leaflet in the packaging. Place the base on the stand, with the wide side facing up. Place the long part of the capsule into the base and the short part into the top (open ends facing outwards).

2. Place the base in a shallow bowl or dish. Pour powder into the base and then distribute the powder using the included dispensing card. 3. If desired, use the tamper to press down the powder and then pour in more powder. Repeat if desired. Wipe the excess powder into the bowl through the open corner. Then lift the bottom of the stand.
4. OPTIONAL IF CAPSULES STUCK WHEN CLOSING: Press the bottom lightly down onto the spring in the middle until the capsules protrude approximately 3 millimeters. Hold this with one hand and place the top onto the bottom with the other hand.
5. Replace the top. Place the device on a flat surface. Press firmly on both sides of the top until the bottom is fully clicked into place.
6. The capsules are automatically closed and held in the top.
7. Press evenly and firmly on the top: The capsules are ejected.

Extra: https://m.youtube.com/watch?v=JO37r628KD

MATERIALS:

The Capsule Machine is made of two types of BPA-free plastic: ABS and Delrin Acetal.

• ABS plastic meets the requirements for contact with food and drinking water, as established by the Food and Drug Administration, the Bundesgesundheitsamt, the British Plastics Federation, and the Bedarfsgegenständeverordnung, in addition to other national and international regulations. ABS is resistant to chemicals and stress cracking from inorganic salt solutions, alkalis, mineral acids (except strong oxidizing acids), and some mineral, vegetable, and animal oils. Petroleum-based oils, solvents, and dyes MUST NOT BE USED, as these can damage the material. Powders with a high eugenol content may potentially affect the plastic. Eugenol is an essential oil found in spices such as cloves, nutmeg, cinnamon, and bay leaf.

• The two springs of the Capsule Machine are made of Delrin Acetal plastic. This material complies with Food and Drug Administration regulations for repeated food contact and National Sanitation Foundation regulations for use in drinking water.

• The divider supplied with all Capsule Machines is made of polypropylene. Among the commercial plastics available on the market today, polypropylene is considered one of the safest. It is FDA-approved for food contact, so you will find polypropylene in food containers such as those for yogurt, cream cheese, and butter products.

CLEANING:

Because the materials inside the Capsule Machine can melt at temperatures near 82°C (180°F), caution is advised when using it in a dishwasher. The heat function of many dishwashers can exceed the maximum temperature. Normally, washing with warm soapy water is sufficient. Be careful when removing the springs from the bottom or top of the Capsule Machine. Ensure that you gently pry the springs loose from the tabs that hold them in place. And if you want to put the springs back in place, first insert one side under the tab and then the other side. Some powders can cause stains on any plastic surface, such as the surfaces of the Capsule machine.